It's my honor to solve your any problem. 4 pcs stepper motor driver DQ542MA. 2 pcs power supply:350W 36V. 1 pc breakout board&cable is free offered. Emperature Rise 80 ° C Max.Ambient temperature Range -20 ° C +50 °. Dielectric Strength 500V AC 1 minute.
There is single flat shaft, dual flats shaft, round shaft, keyway shaft and screw thread shaft, 4 Leads, 6Leads and 8 Leads in different stepper motor with different type. Without informing, we'll send single shaft to you! DQ542MA is a type of two-phase hybrid stepping motor driver, the drive voltage of it is from. It is designed for use with 2-phase hybrid stepper motor of all kinds with. 42mm to 86mm outside diameter and less than 4.0A phase current.This circuit that it adopts. Is smiliar to the circuit of servo control which enables the motor run smoothly almost without.
Holding torque when DQ542MA runs under high speed, is also significantly. Higher than the other two-phase driver, whats more, the positioning accuracy is also higher. It is widely used in middle and big size numerical control devices such as curving machine.CNC machine, and computer embroider machine, packing machines and so on. Average current control, 2-phase sinusoidal output current drive. Supply voltage from 18VDC to 50VDC. Overvoltage, under voltage, overcurrent, phase short circuit protection.
15 channels subdivision and automatic idle-current reduction. 8 channels output phase current setting. Motor torque is related to speed, but not related to step/revolution. High holding torque under high speed. No condensation, no water droplets.
Prohibition of combustible gases and conductive dust. 500Hz, 2G 10min, /11cycle, 60min, each axes. I/P-O/P:3KVACI/P-FG:1.5KVACI/P-FG:0.5KVAC. DB25 output pin:P1, P2, P3, P4, P5, P6, P7, P8, P9, P14, P16, P17. DB25 input pin:P10, P11, P12, P13, P15.Output pins:P1, P2, P3, P4, P5, P6, P7, P8, P9, P14, P16, P17. Input pins:P10, P11, P12, P13, P15. We are professional stepper motor(stepping motor). Supplier and Manufacuturer, and we can manufacture products according to customer's requirement! Our products are mainly used in Robotization, Spinning Automatization, Printing, Packing Medica Machine, Make-up Equipment, Communication, Household Appliance, Water Pump, Milling Machine, Engraver Machine, CNC Routers.. The item "Free to EU! Wantai CNC Kit 4Axis Nema23 Motor 425oz-in single shaft 4.2A&Driver" is in sale since Friday, July 1, 2016. This item is in the category "Business & Industrial\Industrial Automation & Motion Controls\Electric Motors\Stepper Motors". The seller is "zoe-wantmotor" and is located in Rowland Heights, California. This item can be shipped worldwide.