USA4 Axis NEMA 23 Dual Shaft Stepper Motor 425oz-in 112mm+CW5045 Driver CNC Kit. For CNC Router Engraving Machine.
4 x 23HS2430B Nema23 stepper motor (Dual Shaft) 112mm, 425oz-in, 2.8N. M, 3.0A 4 x CW5045 stepper motor driver 24-50V, 4.5A, 256microstep 1 x 400W 36V/9.7A switching power supply 1 x 5 Axis breakout board V5 type 1 x DB25 parallel cable 1 x USB cable.4 Axis for medium size Router Mill Plasma or Laser. It can most connection 5pcs driver and control 5pcs motor in the same time. It is with 4-wire limit switch to insure our safty movement. It is with relay port to contro the cnc spindle.
Working voltage is 5VDC and support with MACH3, EMC2, KCAM4 software. 25-pin parallel port control is defined as follows. The pin of the drive board. B(Fifth axis)pulse signal. X(First axis) pulse signal.X(First axis) direction of the signal. Y(Second axis)direction of the signal.
Z(Third axis) pulse signal. Z(Third axis) direction of the signal. A(Fourth axis) pulse signal.
A(Fourth axis) direction of the signal. B(Fifth axis) direction of the signal. CW5045 high microstep stepper motor driver. Output current: 1.3,1.8,2.3,2.7,3.2,3.7,4.2,4.5A.Mircostepping: 1(1.8°), 1/2,1/4,1/8,1/16,1/32,1/64,1/128,1/256. 1/5,1/10,1/25,1/50,1/125,1/250. Protect form: Overheated protect, lock automatic half current , error connect protect. It is fit for NEMA17-23 two and four phase stepper motors whose current is small than 4.5A. Full current or half current choice : SW4:0=Full current; 1=half current. To avoid use in the oil contamination, dust and corrosive gas environment. To lay it in a place with good ventilation. Pls note the connection with right power(+ and -) to avoid broken the driver.
Pls test it when confirm the connection is right. Step angle accuracy:+ - 5%(full step, not load). Resistance accuracy: + - 10%.
Inductance accuracy:+ - 20%. Temperature rise: 80deg Max(rated current, 2 phase on). Ambient temperature ----------20deg ---- +50deg.
Insulation resistance:100ohm Min, 500VDC. Insultion Strength--------500VAC for one minute. 400W, Input:100-120VAC or 200-240VAC, 50/60Hz, Output:36v/9.7 A, single output switching power supply. Please give us the opportunityto resolve any problem when you have, we concern your problem and we will try our best to resolve it. When you have the parcel, and not satisfied the goods or it is other problem like as broken, pls tell us the detail reason and provide the photos.
The item "USA4 Axis NEMA 23 Dual Shaft Stepper Motor 425oz-in 112mm+CW5045 Driver CNC Kit" is in sale since Friday, April 26, 2019. This item is in the category "Business & Industrial\Industrial Automation & Motion Controls\Drives & Starters\Drives & Motor Controls\Stepper Controls & Drives". The seller is "kuku218" and is located in Dallas,TX. This item can be shipped to United States.